Catalogs > Automation Systems Catalog > Programmable Controllers > SoftLogix5800 Controller > Controllers
Controllers
SoftLogix5800 Controllers
| Cat. No. | Available Slots in Virtual Chassis♣ | Instances of Control Engine, Max. | Support for Communication | Support for Motion Control | Support for Other Modules | Memory |
| 1789-L10 | 3§ | 1 | 2 PCI network interface cards, which can be a mix of:⋆ • one EtherNet/IP card‡ • one 1784-PCICS ControlNet communication card • one 1784-PCIC ControlNet communication card • one 1784-PCIDS DeviceNet communication card |
no motion support | one 1784-SIM module no third-party virtual backplane modules |
2 MB |
| 1789-L30 | 5 | 2 | 5 PCI network interface cards, any mix of: • EtherNet/IP card‡ • 1784-PCICS ControlNet communication card • 1784-PCIC ControlNet communication card • 1784-PCIDS DeviceNet communication card |
• two 1784-PM02AE analog motion cards • one 1784-PM16SE SERCOS motion card |
5 1784-SIM modules third-party virtual backplane modules |
64 MB |
| 1789-L60 | 16 | 6 | 16 PCI network interface cards, any mix of: • EtherNet/IP card‡ • 1784-PCICS ControlNet communication card • 1784-PCIC ControlNet communication card • 1784-PCIDS DeviceNet communication card |
• four 1784-PM02AE analog motion cards • four 1784-PM16SE SERCOS motion cards |
16 1784-SIM modules third-party virtual backplane modules |
64 MB |
| ⋆ Even though the 1789-L10 controller supports two PCI network interface cards, each card must be a different network card. You cannot have two of the same cards installed in the computer. ‡ EtherNet/IP via PCI bus card or embedded EtherNet/IP port on the PC motherboard. § As of firmware revision 12, the 1789-L10 controller now supports 3 slots. ♣ The number of available slots in the virtual chassis is limited by activation level. You can have as many PCI communication cards as you have PCI slots or as you have slots in the virtual chassis, whichever number is smallest. |
||||||