Manual Motor Starters

Catalogs > Industrial Controls Catalog > Motor Control, NEMA > Manual Motor Starters > Bulletin 600 Single Phase

Bulletin 600 Single Phase

Modifications

Modifications — Factory-Installed

Flange Seal (see applicable codes and laws) — This option provides a Type 3 rating in addition to maintaining a Type 7 & 9 integrity. Add the letter S to the end of the cat. no. Example: Cat. No. 600-TEX9S.

Conduit Openings (Type 4 and Type 7 & 9 only) — If two 3/4 in. (19 mm) pipe taps (one on top and one on bottom) are required, add the number 12 to the end of the cat. no. Example: Cat. No. 600-TEX512. Note: Suffix 12 is only an option for the Type 4 and 7 & 9 enclosures.

Note: All single unit devices are provided with one 3/4 in. (19 mm) pipe tap on the bottom. By reversing the switch base, the pipe tap can be located on the top.

All dual units are provided as standard with one 3/4 in. (19 mm) pipe tap on top and two on the bottom with two threaded plugs included. If 1/2 in. (12.7 mm) openings are required, reducers should be used.

Drain — In order to install a drain on single unit devices (i.e. Cat. No. 600-TEX5) an additional conduit opening is required. See “Conduit Openings” above.

Sealing Well with Integral Flange Seal for Type 3, 7, and 9 — To order this option insert the letter R at the end of the listed cat. no. Example: Cat. No. 600-TEX5R.

Sealing Well without Integral Flange Seal for Type 7 and 9 — To order this option insert the letter K at the end of the listed cat. no. Example: Cat. No. 600-TEX5K.