Manual Motor Starters

Catalogs > Industrial Controls Catalog > Motor Control, NEMA > Manual Motor Starters > Bulletin 609U with Under Voltage Protection

Bulletin 609U with Under Voltage Protection

Your order must include: 1) Cat. No. of the manual starting switch with undervoltage protection, 2) Cat. No. of the heater element(s), and 2) if required, Cat. No. of any accessories.

Build a Catalog Number

Product Selection

With Undervoltage Protection

Type Of Operator	Phase	Size	Maximum Horsepower Rating					Open Type without Enclosure	Type 1 General Purpose Enclosure Surface Mounting★	Type 12 Dusttight, Industrial Use Enclosure	Type 4/4X Watertight, Corrosion- Resistant Enclosure Fiberglass- Reinforced Polyester‡	Hazardous Locations
			Motor Voltage									Enclosure Class I, Groups C & D Class II, Groups E, F & G – Divisions 1 & 2
			AC, 60 Hz
			115V	200V	230V	50 Hz	460… 575V					Type 7 & 9	Type 3R, 7 & 9§
						380… 415V		Cat. No.	Cat. No.	Cat. No.	Cat. No.	Cat. No.	Cat. No.
Push Button	1 Æ	0	1	—	2	—	—	609U-AOÄ	609U-AAÄ	609U-AJÄ	609U-ACÄ	609U-AEÄ	609U-AHÄ
		1	2	—	3	—	—	609U-BOÄ	609U-BAÄ	609U-BJÄ	609U-BCÄ	609U-BEÄ	609U-BHÄ
		1P	3	—	5	—	—	609U-XOÄ	609U-XAÄ	609U-XJÄ	609U-XCÄ	—	—
	3 Æ	0	—	3	3	5	5	609U-AOÄ	609U-AAÄ	609U-AJÄ	609U-ACÄ	609U-AEÄ	609U-AHÄ
		1	—	7-1/2	7-1/2	10	10	609U-BOÄ	609U-BAÄ	609U-BJÄ	609U-BCÄ	609U-BEÄ	609U-BHÄ
Toggle Lever	1 Æ	0	1	—	2	—	—	609TU-AOÄ	609TU-AAÄ	—	—	—	—
		1	2	—	3	—	—	609TU-BOÄ	609TU-BAÄ	—	—	—	—
		1P	3	—	5	—	—	609TU-XOÄ	609TU-XAÄ	—	—	—	—
	3 Æ	0	—	3	3	5	5	609TU-AOÄ	609TU-AAÄ	—	—	—	—
		1	—	7-1/2	7-1/2	10	10	609TU-BOÄ	609TU-BAÄ	—	—	—	—
★ Type 1 general purpose flush mounting enclosures with pull box are also available. Order as follows. Change the second letter of the listed cat. no. from A to L. Example: Cat. No. 609U-ALX. For a stainless steel flush plate, change the second letter of the listed cat. no. from A to Q. Example: Cat. No. 609U-AQX.
‡ Fiberglass-reinforced polyester hubs are included with each starter.
§ These enclosures include a cover gasket and drain. It is recommended that a breather also be installed.

Breather	Cat. No. 1401-N1	(Can be installed at the top of an enclosure.)
Drain	Cat. No. 1401-N2	(Can be installed at the bottom of an enclosure.)
Breather-Drain Combination	Cat. No. 1401-N3	(Can be installed at the top of an enclosure as a breather or bottom as a drain.)

Ä Coil Voltage Code for 1-Phase

The cat. no. as listed is incomplete. Select a coil voltage code from the table below to complete the cat. no. Example: Cat. No. 609U-AOÄ becomes Cat. No. 609U-AOXA. For other voltages, consult your local Rockwell Automation sales office or Allen-Bradley distributor.

		[V]	24	110…115	115…120	200…208	220…230	230…240	240	277
Common Control	50 Hz		—	XS	—	—	XP	—	XG	—
	60 Hz		—	XE	XD	XH	XF	XA	—	—
Separate Control	50 Hz		—	XWS	—	—	XWP	—	XWT	—
	60 Hz		XWJ	—	XWD	XWH	—	XWA	—	XWF

Ä Coil Voltage Code for 3-Phase

The cat. no. as listed is incomplete. Select a coil voltage code from the table below to complete the cat. no. Example: Cat. No. 609U-AAÄ becomes Cat. No. 609U-AAA. For other voltages, consult your local Rockwell Automation sales office or Allen-Bradley distributor.

		[V]	24	110	115… 120	200… 208	220… 230	230… 240	240	277	380	415	440… 460	460… 480	500	550	575… 600
Common Control	50 Hz		—	—	—	—	P	—	VP	—	VN	WL	Q	—	WM	R	—
	60 Hz		—	—	—	H	F	A	—	G	—	—	N	B	—	WC	C
Separate Control	50 Hz		K	S	—	—	—	—	—	—	—	—	—	—	—	—	—
	60 Hz		WJ	E	D	—	—	—	—	WF	—	—	—	—	—	—	—

Remote Stop Function

A remote stop function may be added by removing a short jumper (see typical diagram) and wiring a push button or limit switch in series with the solenoid. After operation of the emergency stop, the starter must be manually reset.
Note:The remote stop terminal block and jumper are not available on devices in the Type 7 and 9 enclosure.