MicroLogix™

Description

A MicroLogix™ 1500 processor-based Clutch/Brake Package is a bundle of hardware, software, and documentation that controls the basic clutch/brake mechanisms on mechanical stamping presses. This package requires no user programming. It can be interfaced with other controllers such as the ControlLogix system.

The package uses redundant MicroLogix 1500 processors with application software for self testing and verification to help meet the safety requirements of ANSI B11.1, OSHA 1910.217 and CAN/CSA Z142-M90 press safety regulations for mechanical stamping presses. Each MicroLogix 1500 processor has the basic clutch/brake functionality as well as the basic diagnostics to interface to several display options making it an easy-to-use cost-effective solution for small presses. Since you don’t need programmable controller experience; you can just wire and mount the equipment.

For other press functions such as programmable limit switch, automation control, die protection monitoring and resolver based, consider using the Compact PressMaster system. If you require more automation flexibility or need a custom system, consider using the StamPro system.

Control Features

• Four sets of Run buttons monitored
  
• One set of Inch buttons monitored
  
• AC and DC versions
  
• Hard wired cross-checking
  
• Open communication for diagnostics
  Modes of operation:
  • Off
    
  • Inch
    
  • Single
    
  • Continuous (Armed)
    
• Brake monitoring
  
• Top stop overrun and anti-repeat protection
  

System Requirements

• Rotary Cam Limit Switch or Allen-Bradley Encoder
  
• Motion detection device
  
• Self-checking valve
  

Ordering Information

The purchase of one kit includes the license to use this control on one stamping press.

• Contact your local Rockwell Automation Sales office or Allen-Bradley distributor.
  
• Email inquiries to: metalforming@ra.Rockwell.com
  
• FAX inquiries to: 440-646-4843
  Attention: Metalforming Group
  

The HMI option, which must be ordered in addition to the basic Clutch/Brake package, includes installed software, communication modules, and necessary cables.

New—Enhanced Options for MicroLogix Clutch/Brake Controllers

Option Description	Option Number
HMI Option — Includes PanelView™ Plus 400, network hardware for Ethernet/IP and software for diagnostics, brake monitor setup, and encoder configuration.	PV400
Encoder, scanner module, and software to create a dual encoder feedback system for press position.	PF1
One operator run station on T-stand with run, top stop, and E-stop pushbuttons	RS1