Catalogs > Safety Products Catalog > Logic > Safety Relays > Single-Function Safety Relays > Delayed Outputs > MSR38D/DP
MSR38D/DP
| Introduction |  |
Specifications | |
Wiring Terminations | |
Product Selection | |
Accessories | |
| Approximate Dimensions | |
Block Diagram | |
Typical Wiring Diagrams | |
Applications | |
|
Description
The Minotaur MSR38D/DP is a microprocessor-based, monitoring safety relay, with delayed, safety-rated, solid-state outputs.
The inputs of the MSR38D/DP are the same as the MSR30. They can be connected to gate interlocks, e-stop devices or four-wire safety mats. The gate interlocks and e-stops can be either single channel or dual channel normally-closed circuits.
The reset capability of the MSR38D/DP allows it to set up for monitored manual or automatic/manual reset.
The outputs include two delayed normally-open safety rated outputs that can be connected to loads up to 2 A at 24V DC. These outputs can be used to send a safety stop signal to a machine or manufacturing system. The delay is accomplished by the configuration of jumpers on the terminals. The delay can be easily adjusted by reconfiguring the jumpers.
The MSR38D/DP also has one solid-state normally-closed auxiliary output, which must only be used to indicate the status of the MSR38D/DP. The auxiliary output responds immediately to the change in input status; it is not delayed.
Features
- Category 4 per EN 954-1
- Stop Category 0 or 1
- Two delayed solid-state safety outputs
- One solid-state auxiliary output
- One N.C., two N.C. or safety mat input
- Monitored manual or automatic/manual reset
LED Indicators
| Green | Power (Pwr) |
| Green | K1 Closed |
| Green | K2 Closed |