Single Conditioning
Sampling Modes:
Frequency Range:
1 Hz to 20 kHz
Resolution:
- A/D Conversion: 24 bits
- Dynamic Range: <80dBfs (0.01% fs), -90dBfs (typical)
- FFT Lines / Waveform block size
Amplitude Range:
Dependent on sensitivity
Integration:
Two levels provided, first in hardware, second in firmware
Averaging:
Any number of averages may be specified. If sampling mode is:
- Asynchronous: Averaging will be done on the spectra.
- Synchronous: Averaging will be performed on the time waveforms.
Low Pass Filters:
Independently configured per channel
- Spectra FMAX: 10 Hz - 20 kHz
- gSE Spectra FMAX: 10Hz – 5 kHz
- Optional Overall measurement LP filter: 200 Hz - 20 kHz, Roll Off: -24 dB per octave
High Pass Filters:
Independently configured per channel
- Integration OFF: 1, 5, 10, 40, 1000 Hz, Roll Off: -30 dB per octave for the 1 Hz HPF, otherwise -24 dB per octave
- Integration ON: 5, 10, 40, 1000 Hz, Roll Off:
- Single Integration: -30 dB per octave for the 5 Hz HPF, otherwise -24 dB per octave
- Double Integration: -42 dB per octave for the 5 Hz HPF, otherwise -24 dB per octave
- gSE High Pass Filter: 200, 500, 1000, 2000, 5000 Hz, Roll Off: -12dB/octave
Units:
| g
|
|
mm/s
|
| um
|
psi
|
| ips
|
mils
|
| volt
|
Pa
|
|
